See “Assembling/disassembling backrest” for
instrucons for removing the backrest.
1. Place booster seat rmly against the back of a
forward-facing vehicle seat. The vehicle seat MUST
be equipped with a 3-point lap-and-shoulder belt.
Booster must be level, stable and not rock side-to-
side (see “Vehicle seang posions”).
2. Place child in the booster seat with child’s back at
against the vehicle seat.
3.
❶
4. Buckle vehicle seat belt into place. Ensure the buckle
is secure by gently pulling on it.
! BOTH SIDES OF THE LAP BELT MUST PASS UNDER
BOTH ARMRESTS, AND THE LOWER END OF THE
SHOULDER BELT MUST PASS UNDER THE ARMREST
ON THE BUCKLE SIDE.
! Any straps holding the restraint to the vehicle should be
ght, any straps restraining the child should be adjusted
to the child’s body, and the straps should not be twisted.
! THE VEHICLE’S SHOULDER BELT MUST LIE ACROSS
THE CHILD’S SHOULDER AND LAY ACROSS THE CHEST
– NOT THE FACE OR NECK. If the belt does not lie
properly across the child’s shoulder and chest, the RED
shoulder belt guide (“Parts list - G”) MUST be used to
ensure proper placement (see “Using shoulder belt
guide”).
21
❶
To Next Page
Loading...
