! DO NOT allow the child to slouch,
slide down in the seat, or create slack
in the belt system ❺. If child will not
keep vehicle belt properly posioned,
DO NOT use this booster seat.
! NEVER posion vehicle belt over top
of the armrests ❻.
! The vehicle seat headrest should not
create a gap between vehicle seat and booster seat
❼. If so, remove the vehicle headrest.
! DO NOT use any load bearing contact points other
than those described in the instrucons and marked in
the child restraint.
❹
❻
❼
❺
IF IN DOUBT ABOUT THESE POINTS OR ANY
QUESTIONS RELATED TO INSTALLATION, PLEASE
CONTACT HARMONY JUVENILE PRODUCTS.
DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder porons of the seat belt
are properly posioned and the buckle is aached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
WARNING!
!
19
To Next Page
Loading...
