Harmony Merydian - Page 19

19
3. To adjust the height of the harness,
remove both sides of the shoulder
straps from the metal splier
plate on the rear of the seat (see
“Removing/installing harness”).
4. Gently pull the straps out from the
front harness slots.
5. Select the proper harness slot height
and feed the straps back through.
ENSURE THAT THE HARNESS
STRAPS ARE THREADED AT THE
SAME LEVEL, ARE NOT TWISTED
AND ARE IN THE CORRECT SLOTS.
6. Reaach the harness
strap to the metal
splier plate ❸.
! ENSURE BOTH HARNESS
STRAPS ARE PROPERLY
SECURED ON THE SPLITTER PLATE.
REMEMBER to check the shoulder straps posion
frequently and move them to the next posion
when necessary. When REAR-FACING, the harness
straps MUST be in the height posion EVEN with or
just BELOW the
shoulders. When
FORWARD-FACING,
the harness straps
MUST be in the
height posion EVEN
with or just ABOVE
WARNING!
!
FAILURE TO REINSTALL THE HARNESS STRAPS
CORRECTLY COULD RESULT IN SERIOUS INJURY OR
DEATH.
❶
❷
❸