Harmony Merydian - Installing Forward-facing

22
1. Place the child restraint ush
against the back of a forward-facing
vehicle seat. Adjust the recline as
necessary (see “Recline”).
2. Thread the vehicle shoulder belt
poron of the seat belt through
the integrated belt posioning
guide at the top of the headrest
ON THE SAME SIDE as the seat
belt retractor ❶.
3. Gently pull apart
the hook and
loop seam found
on the backrest
of the seat pad
exposing the
shell and EPE foam. Guide the shoulder poron of
the vehicle 3-point seat belt along the backrest and
completely through the opening on the side of the
child restraint and out the back as shown ❷.
❶
INSTALLING FORWARD-FACING
length manually back into the retractor unl the seat
belt is taught and has no slack ❹.
For more informaon on how to ghten the seat belt for
your seat belt system, see your vehicle owner’s manual.
! WARNING: Rear-facing cars seats must be properly
levelled:
• Too reclined can result in injury;
• Too upright can result in breathing dicules.
! ENSURE that your infant is resng in the car seat in a
way where their head cannot fall forward easily on its
own.
! ENSURE that your infant’s boom and back are at
against the child restraint and that your infant does
NOT slouch.
❷
❹
❸