Harmony Merydian - Page 25

25
❺
2. Unbuckle harness straps by
pressing on the RED buckle
release buon and by pulling the
buckle clips out ❸. Move harness
straps to the side.
3. Place child in child restraint with
child’s back at against back of the
backrest.
4. Place harness straps
over child’s shoulders
and insert the two-
piece buckle clip into
buckle unl they ‘click’
into place ❹.
! ENSURE that the buckle
is properly fastened by gently
tugging on it.
! ENSURE that the straps are NOT
twisted.
! DO NOT use child restraint if
harness does not lock.
5. Tighten harness system by gently
pulling on the up-front harness
adjuster strap unl all slack is
removed from the system ❺.
! ENSURE straps are at and snug
against child’s shoulders and thighs.
You should NOT be able to slide
more than one nger between the
strap and the child’s shoulder ❻.
A snug strap should not allow any
slack. It lies in a relavely straight line without sagging.
It should not press the child’s esh or cause your child’s
body to be in an unnatural posion.
! Any straps holding the restraint to the vehicle should be
ght, any straps restraining the child should be adjusted
to the child’s body, and all straps should not be twisted.
❻
❹
❸