○ It is recommended to put the installation of the water treatment unit in bypass
configuration.
○ Install the water treatment unit on a solid basis.
○ Always keep the product upright. If the product is tilted or laid on the side, the
electrodes cannot measure correctly.
○ The product must be installed inside. If you want to do this outdoors, you need to
contact your, supplier.
○ The dosing device mag shall not be used with hydrochloric acid (HCl)..
○ The electronics (dosing devices) of the appliance must be installed inside. Make sure that
- in case of leak - the water cannot run over the installation.
○ Make sure that the acid container is placed OUTSIDE or in a verywell-fertilizedspace.
○ Calibrate the pH and Rx electrodes for the first use and then "regular". (At least every
3months).
To Next Page
Loading...