105
Scan Operations (2)
PGM – SYS PRESETS - SCAN - VULOS
SCAN LIST
HANG / HOLD TIME
PRIORITY
. . . PRESETS - SCAN - VULOS - HANG / HOLD
HANG TIME DURATION
3 SECONDS
ENTER HANG TIME FROM 01 -99
0
. . . PRESETS - SCAN - VULOS - PRIORITY
PRIORITY TX PRESET
TO SCROLL / ENT TO CONT
FMVOICE01
. . . PRESETS - SCAN - VULOS - PRIORITY
RX PRIORITY SCANNING
TO SCROLL / ENT TO CONT
ENABLE
. . . PRESETS - SCAN - VULOS - PRIORITY
PRIORITY RX PRESET
TO SCROLL / ENT TO CONT
FMVOICE02
PGM – SYS PRESETS - SCAN - VULOS
SCAN LIST
PRIORITY
HANG / HOLD TIME
. . . PRESETS - SCAN - VULOS - HANG / HOLD
HOLD TIME
TO SCROLL / ENT TO CONT
ENABLE
. . . PRESETS - SCAN - VULOS - HANG / HOLD
HOLD TIME DURATION
5 SECONDS
ENTER HOLD TIME FROM 01 -99
0
Select PRIORITY. Select a PRIORITY TX PRESET by scrolling through presets
added to the scan list. The Priority Transmit Channel is the net that the radio will
transmit on when it is actively scanning and the PTT button is pushed. If the
radio is paused on a different net, it will transmit on that net when the PTT button
is pushed. A Priority Transmit Channel may be programmed by the operator. If
one is not assigned, the first net in the scan list defaults to the priority transmit
channel.
RECEIVE PRIORITY SCANNING is either ENABLED or DISABLED. If
ENABLED, select the PRIORITY RX PRESET. Priority Receive Channel is
scanned every other time during the scan sequence.
Select HANG/HOLD TIME. Hang Time is the length of time the radio dwells on a
net after the received signal ends before returning to scanning. Enter 1 to 99
seconds. Hold Time is the length of time the radio dwells on a net before
returning to scan even if still receiving a signal. HOLD TIME defaults to OFF; if
ENABLED, enter 1 TO 99.
Press PGM to exit and return to the Operational Screen.
To Next Page
Loading...
