118
Loading SINCGARS FH Data (3)
Send Receive Database
sEtup Comsec Time
Send to:
Radio Ancd Stu Pc
Select: iCom Nonicom
Abn Rcu Haveq
Do you want to include
time? (Y/N)
Press [Load] on RT
Using RDS software from a AN/CYZ-10 use the following steps.
• Select Send.
• Select Radio.
• Select iCom.
• Follow instructions to until (Connect to RT AUD/FILL Connector) is displayed,
press ENTR.
• (Set FCTN Switch to LD on RT) is displayed, press ENTR
• (Do you want to include time?) If the correct date and time are in the DTD,
select Y; otherwise select N.
• The DTD will display (Press [LOAD] on RT) for a few seconds then change to
display each of the 6 COMSEC keys as they are loaded. Then the DTD will
load each of the 6 ESETs, one at a time.
• If there were no errors, the DTD will display (ICOM transfer successful). At
this time you can disconnect the AN/CYZ-10.
To Next Page
Loading...
