119
Loading SINCGARS FH Data (4)
Initializing Fill Port…
Press LOAD Button.
Sending TEK #1
Sending TEK #2
Sending TEK #3
Sending TEK #4
Sending TEK #5
Sending KEK #6
Sending Cold Start TSK
Sending Hopset #1
Sending Hopset #2
If using a AN/PYQ-10 SKL (Simple Key Loader), use the following steps. The
radio setup is the same as with the AN/CYZ-10.
• After you have logged into the SKL select the Eqs Tab .
• Select RT-1523 or SINCGARS then press the LOAD icon in the top right of the
screen.
• At the SINCGARS Mode screen, select ICOM Transfer and Include Time (if
needed). Press OK.
• At the Connect To screen, connect the SKL to the RT then press Next>>
• At the Profiles screen, ensure the radio displays INITIATE FILL AT FILL
DEVICE, then press Send on the SKL.
• The Status screen displays ‘Press LOAD Button.’ for about a second.
• If the connect is good and there are no errors, the SKL will display ‘Sending
TEK #1 - #5, KEK #6 , Sending Cold Start TSK, Sending Hopset #1 - #6 and 8
Lockouts.
• When complete the SKL will display ‘Re-load equipment’. At this time you can
disconnect the SKL.
To Next Page
Loading...
