215
Configuring the Network
• The next step will be to configure the network
parameters.
TX Power
Info Type (Traffic)
Additional information
Error on entry
•Click anywhere below the radios in the white area of the Network tab or on the
(Click here to configure FFNET1) words at the very bottom of the Network tab.
The Network properties can now be edited to the right.
• Some items are direct entry while others must be selected from a drop-down
box such as TX Power.
• If an error occurred during direct entry, an error notification will appear providing
information on how to correct the error.
• Selecting the name of the entry item will provide additional information at the
very bottom of the properties window.
• The network properties should be configured from top to bottom. The choices
for later entries can change based on previous entries.
• If additional networks need to be added, repeat the last three steps.
To Next Page
Loading...
