Harris FALCON III - Page 239

237

Programming ANW2 (1)
8 VWX
PGM
PGM
RADIO CONFIG
VULOS CONFIG
SYSTEM PRESETS
PGM – SYS PRESETS
RESET SYSTEM PRESET
SYSTEM SCAN CONFIG
SYSTEM PRESET CONFIG
PGM – SYS PRESETS - CFG
SYSTEM PRESET NUMBER
1- ANW2NET1
ENTER 01 – 99 / PRE + / -TO SCROLL
0
PGM – SYS PRESETS – CFG - 00
PRESET DESCRIPTION
NSERT DESCRIPTION
ENTER DESCRIPTION
I
PGM – SYS PRESETS – CFG - 01
PRESET WAVEFORM
TO SCROLL / ENT TO CONT
ANW2
PGM – SYS PRESETS – CFG – 01 – ANW2
BLACK SIDE INTERFACES
VOICE CONFIG
GENERAL CONFIG
PGM – SYS PRESETS – CFG – 01 – ANW2 - CONFIG
PRESET NAME
NW2NET1
ENTER ALPHANUMERIC PRESET NAME
A
Again, only a few items can be programmed from the face plate. A majority of
the ANW2 programming is performed using the CPA.
Press the PGM button and select System Presets then System Preset Config.
Scroll to and select the ANW2 preset.
The Preset Description can be changed.
Do not change the Preset Waveform, leave it as ANW2. This is the only item
under General Config.
Select General Config and change the Preset Name if desired.