238
Programming ANW2 (2)
. . 01 – ANW2 – BLACK SIDE INTERFACE
ANW2 WIDEBAND
TO SCROLL / ENT TO CONT
ENABLED
PGM – SYS PRESETS – CFG – 01 – ANW2
GENERAL CONFIG
VOICE CONFIG
BLACK SIDE INTERFACES
. . 01 – ANW2 – BLACK SIDE INTERFACE
BGAN
TO SCROLL / ENT TO CONT
DISABLED
. . 01 – ANW2 – BLACK SIDE INTERFACE
BLACK LAN
TO SCROLL / ENT TO CONT
DISABLED
PGM – SYS PRESETS – CFG – 01 – ANW2
GENERAL CONFIG
BLACK SIDE INTERFACES
VOICE CONFIG
. . ETS –CFG-01– ANW2–BLACK SIDE INTERFACE
VOICE CRYPTO KEY
TO SCROLL / ENT TO CONT
TEK 01
Black Side Interface
Voice Configuration
There are 3 items under Black Side Interface: ANW2 Wideband, BGAN, and
Black LAN. These normally should not be changed by the operator but left for
the S-6 shop to configure in the CPA. These three items are the possible
transmission paths for data coming from the Red LAN port.
When ANW2 Wideband is enabled the radio utilizes the High-band antenna port
on the radio.
If BGAN (Broadband Global Area Network) is Enabled it requires an INMARSAT
(International Marine Satellite) terminal. Usage of INMARSATs is very costly and
the traffic class must be configured based on what was purchased. Background
is charged by the amount of data in bytes and Streaming is charged by time
using 4 different data rates. If BGAN was Disabled it’s best to leave Disabled.
Black LAN should also be left at Disabled unless configured by the S-6.
Only one item is in Voice Config; Voice Crypto Key. Select the correct key
position (TEK01 – TEK25).
To Next Page
Loading...
