64
Loading Single COMSEC Key (2)
AN-CYZ-10 RDS settings
Send Receive Database
sEtup Comsec Time
vG Ld Rv
Ak MK vU
Select:
Tek Kek
Select key qUit
USKAT1234 XMT
Press [Load] on RT
If using RDS (Radio) software from a AN/CYZ-10 use the following steps:
• Select COMSEC
• Select LD
• Select the key type (TEK or KEK)
• If necessary press the P DN (page down) to locate the correct key
• Press the ENTR button to ‘tag’ the key. XMT will be in the lower right. Be sure
to tag only one key. Pressing the ENTR button again will un-tag the key.
• Select qUit
• Connect ANCD to RT is displayed on the AN/CYZ-10, press ENTR or the down
arrow button
• Sending TEK USKAT1234 (for example) is displayed.
• Press [LOAD] on RT is displayed. NOW press the ENT button on the radio.
To Next Page
Loading...
