Harris XL Series - 1.3.2 Approved Accessories; 1.3.3 Contact Information; 1.4 REGULATORY APPROVALS

14221-1850-4000
10
1.5 REGULATORY APPROVALS
1.5.1 Applicable Type Acceptance/Certification Numbers
FCC Type Acceptance:
XL-185M: OWDTR-0160-E
Applicable FCC Rules: Part 2, Part 15B, Part 15.247, Part 15.407, Part 24, Part
90 and Part 101
Industry Canada Certification:
XL-185M: 3636B-0160
Applicable Industry Canada Rules: RSS-247, RSS-119, ICES-003 Issue 6
1.5.2 FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
1.5.3 Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
1.6 OCCUPATIONAL SAFETY GUIDELINES AND SAFETY TRAINING
INFORMATION
To ensure bodily exposure to RF electromagnetic energy is within the FCC allowable limits for
occupational use. Always adhere to the following basic guidelines:
• The push-to-talk button should only be depressed when intending to send a voice message.
• The radio should only be used for necessary work-related communications.
• The radio should only be used by authorized and trained personnel. It should never be operated by
children.
• Do not attempt any unauthorized modification to the radio. Changes or modifications to the radio may
cause harmful interference and/or cause it to exceed FCC RF exposure limits. Only qualified
personnel should service the radio.
• Only use authorized accessories (antennas, Control Heads, speakers/mics, etc.). Use of unauthorized
accessories can cause the FCC RF exposure compliance requirements to be exceeded.