12/20/11 888-2595-001 A-5
WARNING: Disconnect primary power prior to servicing.
Appendix A - FM Web Remote Option
ZX Series
STEP 11 Attempt to access configuration page via procedure in section A.5.1.
Default password is "expert". Default IP address is 192.168.1.99 unless
otherwise indicated.
To access the web remote for the first time, there are two different options:
• 1:1 connection to PC: Use a crossover type cable, and the PC should have its
IP address manually set to 192.168.1.xx, where xx is 0-255, but not 99.
• Connection to router: Some router types use a default address of
192.168.1.1. (e.g. LINKSYS) In such a case, the web remote may be
connected directly to the router via a straight (non-crossover) cable.
STEP 12 If web remote will not respond to IP address of 192.168.1.99, perform an
expert reset per procedure in section A.5.3.
STEP 13 On configuration page, set IP address to final desired address. Where
indicated, access router configuration page and set port 80 forwarding to
web remote IP address. Set other user parameters per information given
in Table A.5.1.
STEP 14 Access main page via procedure in section A.3.1.
STEP 15 Verify web remote properly commands and monitors transmitter.
STEP 16 Change configuration settings as desired until satisfied with all aspects
of web remote operation (passwords, SMTP, SNMP, etc).
STEP 17 Record all configuration settings on paper and store in safe place for
future reference. (passwords, addresses, etc)
STEP 18 Procedure complete.
A.3 Operation
All monitoring, logging, and commands are on a single, straightforward, main web
page. Use this procedure to access the main page.
A.3.1 Access main page
STEP 1 Open web browser on PC.
STEP 2 Enter IP address of web remote (preceeded by http://) on address line
and press RETURN.
STEP 3 Empty page with "PASSWORD?" prompt should be displayed.
To Next Page
Loading...