What to do if the Watchdog Timer Alarm is logged in the Alarm queue for my Harris Transmitter?
If a Watchdog Timer Alarm is logged, examine the MAIN raw data screen to check for a record of an Exception.
What to do if a Harris Transmitter power supply exhibits a fault condition?
If a power supply shows a fault, try swapping its control board with one from another power supply, or use a spare if available. If the problem follows the control board, then the control board needs to be replaced.
What to do if the problem stays with the power supply of my Harris Transmitter?
In case the issue remains with the power supply, first disconnect all power to the cabinet containing the power supply. Then, remove the power supply from the cabinet and take off the lid. Proceed to check for any failed SCRs.
General| Modulation | ATSC, DVB-T, ISDB-T |
|---|---|
| Cooling | Liquid |
| Redundancy | Optional N+1 |
| Channel Spacing | 6 MHz, 7 MHz, 8 MHz |
| Dimensions | Varies depending on model |
| Weight | Varies depending on model |
| Operating Temperature | 0°C |
To Next Page