HART 475 - European Directive Information - CE Compliance; Hazardous Locations Certifications (KL Option Only)

Product Certifications
11
FCC
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
Any modifications made to this device that are not approved by Emerson Process
Management may void the authority granted to the user by the FCC to operate this
equipment.
European Directive Information — CE Compliance
Electromagnetic Compatibility (2004/108/EC)
Tested to the EN 61326-1 specification.
R&TTE
This equipment complies with the Radio and Telecommunications Terminal
Equipment (1999/5/EC) Directive.
ATEX Directive (94/9/EC) (KL option only)
Emerson Process Management complies with the ATEX Directive. Applicable
standards are EN 60079-0, EN 60079-11, EN 60079-26, and EN 60079-27.
Specific ATEX Directive Information is located within this document and the
475 Field Communicator User’s Manual.
Hazardous Locations Certifications (KL option only)
The Intrinsic Safety approvals listed in this section include compliance with the FISCO
requirements.
North American Certifications
Factory Mutual (FM)
Intrinsically Safe for Class I, Division 1, Groups A, B, C, and D and Class I,
Zone 0, AEx ia IIC T4 (Ta = 50°C) hazardous locations when connected as
indicated in the control drawing 00475-1130 in the 475 Field Communicator
User’s Manual. See the control drawing for input and output parameters.
Canadian Standards Association (CSA)
Intrinsically Safe for use in Class I, Zone 0, Ex ia IIC T4 (Ta = 50°C) hazardous
locations when connected as indicated in the control drawing 00475-1130 in
the 475 Field Communicator User’s Manual. See the control drawing for input
and output parameters.