HART HTMS01 - Operation; To Support Long Workpieces

25 – English
 Graspthestockfirmlywithonehandandsecureitagainst
thefence.Usetheworkclamp,C-clamp,orothersuitable
clamptosecuretheworkpiecewhenpossible.
 Beforeturningonthesaw,performadryrunofthecutting
operationjusttomakesurethatnoproblemswilloccur
whenthecutismade.
 Graspthesawhandlefirmly.Depressthetriggerlockout
leverandsqueezetheswitchtrigger.Allowseveralsec-
ondsforthebladetoreachmaximumspeed.
 Slowlylowerthebladeintoandthroughtheworkpiece.
 Releasetheswitchtriggerandallowthesawbladetostop
rotatingbeforeraisingthebladeoutoftheworkpiece.
Waituntilthebladestopsturningbeforeremovingthe
workpiecefrommitertable.
TO SUPPORT LONG WORKPIECES
See Figure 30.
Longworkpiecesneedextrasupports.Supports,rollerstand,
orworksurfacelevelwiththesawtableshouldbeplaced
alongtheworkpiecesoitdoesnotsag.Thesupportshould
lettheworkpiecelayflatonthebaseofthesawandwork
tableduringthecutting operation.Usethework clamp,
C-clamp,orothersuitableclamptosecuretheworkpiece
whenpossible.
LONG
WORKPIECE
WORKPIECE
SUPPORTS
OPERATION
FIG. 30