HART HTMS01 - Operation; Applications; Cutting with Your Compound Miter Saw

21 – English
WARNING:
To avoid serious personal injury, always tighten the
miterlockknobandthebevellockknobbeforemaking
acut.Failuretodosocouldresultinmovementofthe
controlarmormitertablewhilemakingacut.
WARNING:
Toavoidseriouspersonalinjury,keephandsoutsidethe
nohandszone,atleast4in.(100mm)fromtheblade.
Neverperformanycuttingoperationfreehand(without
holdingworkpieceagainstthefence).Thebladecould
grabtheworkpieceifitslipsortwists.
NOTICE:
Donotstartthecompoundmitersawwithoutchecking
forinterferencebetweentheblade,thepartialsliding
miterfence,andthemiterfence.Damagecouldresult
tothebladeifitstrikesthemiterfenceduringoperation
ofthesaw.
CUTTING WITH YOUR COMPOUND
MITER SAW
WARNING:
WhenusingaworkclamporC-clamptosecureyour
workpiece,clampworkpieceononesideoftheblade
only.Theworkpiecemustremainfreeononesideofthe
bladetopreventthebladefrombindinginworkpiece.
The workpiece binding the blade will cause motor
stallingandkickback.Thissituation couldcausean
accidentresultinginpossibleseriouspersonalinjury.
WARNING:
NEVERmovetheworkpieceormakeadjustmenttoany
cuttinganglewhilethesawisrunningandthebladeis
rotating.Anyslipcanresultincontactwiththeblade
causingseriouspersonalinjury.
WARNING:
Donotallowfamiliaritywithtoolstomakeyoucareless.
Remember that a careless fraction of a second is
sufficienttoinflictseriousinjury.
WARNING:
Alwaysweareyeprotectionwithsideshieldsmarked
to comply with ANSI Z87.1. Failure to do so could
resultinobjectsbeingthrownintoyoureyes,resulting
inpossibleseriousinjury.
WARNING:
Do not use any attachments or accessories not
recommendedbythemanufacturerof thistool.The
useofattachmentsoraccessoriesnotrecommended
canresultinseriouspersonalinjury.
APPLICATIONS
Thisproducthasbeendesignedonlyforthepurposeslisted
below:
 Crosscuttingwood,woodcompositionandplastic(do
notcutmetals,ceramics,ormasonryproducts.)
 Crosscuttingmiters,joints,etc.forpictureframesmold-
ings,doorcasings,andfinejoinery
 Bevel cutting and compoundcuttingoflumber and
moldings.
NOTE:The bladeprovidedisfineformost woodcutting
operations,butforfinejoinerycutsorcuttingplastic,use
oneoftheaccessorybladesavailablefromthedealer.
WARNING:
Beforestartinganycuttingoperation,clamporboltthe
compoundmitersawtoaworkbenchoranapproved
workstand.Neveroperatethemitersawonthefloor
orinacrouchedposition.Failuretoheedthiswarning
canresultinseriouspersonalinjury.
OPERATION