14
EN
Basic mode (heater and steamer on)
The top row shows the sauna room temperature. The bottom row shows the
humidity level (or remaining on time, if the steamer is not activated).
Press the MENU button to open the settings menu.
Sauna room temperature (shown if the heater is activated)
The display shows the sauna room temperature setting. Temperature
indicator light blinks.
•
Change the setting to the desired temperature with the and buttons.
•
The sum of temperature and humidity can be 140 at maximum
Press the MENU button to access the next setting.
Sauna room humidity level (shown if the steamer is activated)
Change the setting to the desired humidity with the and buttons.
• The display shows the sauna room humidity setting.
Humidity indicator light blinks.
• The sum of temperature and humidity can be 140 at maximum.
Press the MENU button to access the next setting.
Remaining on-time
Press the
and buttons to adjust the remaining on-time.
Example: the heater will be on for 40 minutes.
Pre-setting time (timed switch-on)
• Press the button until you overstep the maximum on-time (1h).
Temperature and humidity indicator lights switch off. Pre-setting time
symbol blinks on the screen.
• Select the desired pre-setting time using the
and buttons
. The
time changes in 10-minute steps.
Example: the heater will start after 10 minutes.
Press the MENU button to exit.
Basic mode (pre-setting time running, heater and steamer off)
The decrease of remaining pre-setting time is shown until zero appears, after
which the activated devices (heater and/or steamer) are switched on. The
bottom row shows the remaining pre-setting time.
Figure 3a. Settings menu structure, basic settings.
BASIC SETTINGS
To Next Page
Loading...
Need help?
General
