Hasler IM-330 - How to Change System Time-Outs

Setting Default Time-Outs
How to Change System Time-Outs
To change the system time-Outs:
1. As Supervisor (see How to Log in as Supervisor on page 126 )
Press and type 3.5 or select the path:
Default user settings System settings Time-out settings
The Timeout setting screen is displayed.
2. Select each field and specify the length of each the time-out.
Use the [C] key to clear old settings then enter a new value.
3. Specify the length of each time-out using the keypad and press [OK] to display the
next screen, until the Summary screen is displayed.
Use the [C] key to clear old settings then enter a new value.
4. Press [OK] to validate.
136
| Page 136 | jan-17-2014 02:10 |
8
Configuring your Mailing System