Hasler Sound 2 - Intended Use, Target Audience, and Contraindications; Glossary and Abbreviations

COMMISSIONING MANUAL
____________________________________________________________________________________
__________________________________________________________________________________
Page 12/32
SOUND2.943.001-E.e
9. Electrical interface
Unscrew and remove the lower cover to use the terminals.
J1: Microphone Input: Connected to
the microphone by a single pole
cable, shielded type (Gauge A.W.G:
22-24) diameter between 2.5mm and
7mm.
J2:Digital Outputs
J3: Analog
Output
0 / 10V
J10: Analog
Output
0/4-20mA
J11: Diaphony
OUT
J7: Diaphony
IN
J4:
Communication
Profibus DP
MODBUS RTU
J9:
Communication
MODBUS TCP
J22: Future
Connexions
Picture 5 : Sound 2 Interface
All the electrical cables must be shielded.
The shield must be connect to the ground reference (cable gland)