Hasler Sound 2 - Microphone Installation

COMMISSIONING MANUAL
____________________________________________________________________________________
__________________________________________________________________________________
Page 7/32
SOUND2.943.001-E.e
5. Microphone Installation
The microphone fitted with two holes (diameter 13mm) 120mm spacing,
has to be set with a rigid support.
Firstly, the needed cable length has to be determined and the microphone interface must be
assembled.
The cable has to be protected by a sleeve up to the microphone connector.
It is advisable to set firstly the microphone on a temporary support in order to find the place, where
the maximum signal is obtained.
Picture 1 : Microphone system dimensions
Warning!
The microphone cable must be absolutely protected against electro magnetic
perturbation (avoid same cable path for power cable especially from motor).