This manual supposes the use of a version 1.0.0.1 or Higher of the Sound 2 software
It cannot be used for previous versions.
Service
If you need assistance, please call your local service center:
HASLER Group SA Tel. +33 (0)4 74 16 11 50
F- 38780 Pont-Évêque Mail: service.fr@hasler.group
HASLER Suisse Sarl Tel. +41 (0)32 720 23 00
CH-2000 Neuchâtel Mail: service.ch@hasler.group
HASLER Deutschland GmbH Tel. +49 (0)2571 540 340-0
D-48268 GREVEN Mail: service.de@hasler.group
HASLER Industrial Equipment Tel. +86 21 59 10 60 58
CN-201801 Shanghai Mail: service.cn@hasler.group
Before you call...
➔ Do you have alarm displays?
Are you able to eliminate the cause of the alarm displays?
➔ Have you modified part of the system, Microphone, Cable, product or operating mode?
➔ Have you tried to remedy the fault in accordance with the operating and service instructions?
➔ Please note
The Job Number: _______________________________
The type of mill: _______________________________
The Part Number of Controler _______________________________
“No part of this publication may be reproduced or transmitted in any form or by any means electronic or
mechanical including photocopy, facsimile or computer-generated distribution without written permission from
HASLER Group. All translation rights are reserved by HASLER Group. HASLER Group has made every effort
to ensure the accuracy and validity of this document. However, errors or emissions cannot be excluded and may
be transmitted to HASLER Group, at the following number: +33 (0) 4 74 16 11 50.
Information in this manual is correct as of the date of publication. HASLER Group assumes no responsibility for
damages resulting from misuse of the equipment or negligence on the part of operating personnel.
HASLER Group also reserves the right to modify equipment, products, programs, and procedures described in
this manual at any time without prior notice.
To Next Page
Loading...
