Step 2) Fill first channel of humidity tray
● Check room humidity levels with a hygrometer before incubation
○ If room is below 50%, always keep at least 1 channel on the humidity tray filled
○ If room is over 50%, do not fill humidity tray but leave within the incubator
Caution! NEVER REMOVE HUMIDITY TRAY - will affect calibration
Caution! Never fill humidity tray with cold water, must be room temperature: 77-86
0
F (25-30
0
C)
Caution! Always keep the tray at the bottom, even when empty
Caution! Keep full during the last 2-3 days.
Step 3) Install Conturn
TM
30 Egg Trays
1. Adjust egg rack, if necessary (See Page 9)
2. Slide egg turner into incubator
3. Plug in distribution cords
To Next Page
Loading...
