Form No. DHLM-1207
2
IMPORTANT SAFETY INFORMATION
CAUTIONS
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
Unit is not weatherproof. For safe and proper
operation locate the unit indoors
where the
ambient air temperature is constant and is a
minimum of 70°F (21°C).
For safe and proper operation do not use
Trac system units with a power supply cord
or convenience receptacle adapter.
To reduce the risk of fire and electric shock
when installing Trac systems, use only fixture
assemblies marked for use with Halo Trac,
and Trac Fittings marked for use with L650
Series Trac.
For safe and proper operation the maximum
capacity of Power-Trac is 20A per circuit.
Check the fuses and circuits carefully before
installing. 20A maximum includes all lights
and appliances connected to the circuit. 120
volt only, maximum 1920 watts per any length
track.
For safe and proper operation be careful
during Trac installation that you do not
damage the buss bar insulators during the
drilling operation. If insulators are damaged,
discard the section and do not use.
For safe and proper operation do not damage
the special, smooth plastic finish piece on
metal ceiling plate when determining location
of proper knock out holes.
For safe and proper operation on units not
equipped with Hatco supplied switch (N-no
switch), a qualified electrician must choose
an appropriate switch for the application
based on amperage and inrush rating of the
switch.
All canopy mount units are designed to fit a
standard 4" (102 mm) octagonal junction box.
To prevent any injury or damage this junction
box must be securely anchored to the
building structure.
For safe and proper operation, multiple
installations of Decorative Heat Lamps must
have a minimum clearance of 12" (305 mm)
between each unit.
NOTICE
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your
Decorative Heat Lamp, marring its
appearance and making it susceptible to dirt
accumulation.
Damage to any countertop material caused
by heat generated from Hatco equipment is
not covered under the Hatco warranty.
Contact the manufacturer of the countertop
material for application information.
Hatco DL lamp warmers are built to fit HALO
brand L651, L652 and L653 Power Trac, track
lighting systems only. Do not attempt to use
on any other track lighting system.
To Next Page
Loading...
Need help?
General
