HATO 200C - Adding Extra Transmitter (Learn)

11
display number from ’99’ to ’11’, when ‘▬ ▬’ appears on the LED display, the operator is
now in normal state.
Fig.12
Transmitter
 Button 1, button 2, button 3: The remote control works in a single channel mode. With
each press of the remote control button which has been programmed, the gate will open,
stop, close or stop cycle.
 Button 4: LOCK button
Fig.13
Adding extra transmitter (learn)
1. Press the CODE, ‘Su’ is indicated on the LED display.
2. Press the transmitter button which you want to use (button 1, 2, 3), then press the same
button again.
3. ‘Su’ on the LED display will flash.
4. ‘▬ ▬’ is indicated on the LED display, then the learning process is finished.
Up to 20 transmitters may be used.