2G40, 2G40 H Safety
HATZ
19Operator’s Manual
NOTICE
▪ The necessary wiring diagrams are included with the ma-
chine if it is equipped with electrical equipment. Additional
wiring diagrams can be requested when needed.
▪ We cannot be held liable for electrical equipment that is not
designed according to HATZ wiring diagrams.
▪ Promptly replace faulty indicator lamps.
▪ Do not pull out the starting key during operation.
▪ Do not disconnect the battery while the machine is running. Resulting volt-
age peaks could destroy the electronic components.
▪ When cleaning, do no spray the electrical equipment components with a
water jet or high pressure cleaner.
▪ When performing welding work on the machine, disconnect the battery
and place the ground clamp of the welding equipment as close as possible
to the welding area. Disconnect the plug-in connection to the voltage regu-
lator.
3.3 Labels
Warning labels and information signs on the engine
Label Meaning
2G40
= 1h
max
OIL
OIL
0,1 mm
0.004"
max
0000 040 096 02
500h
250h
Maintenance instructions (see chap-
ter 8.2.2 Maintenance plan, page
51
Refuel with diesel fuel only. For the
specification, see chapter 4.5 Fuel,
page 23.
Do not use bio diesel.
The engine may only be operated
with fuel that is "EXTREMELY LOW
IN SULFUR OR SULFUR-FREE".
The fuel label is located close to the
fuel cap. If there is no fuel tank in-
stalled on the engine, the label must
be applied permanently close to the
fuel filler opening.
To Next Page
Loading...
