Hatz 2G40 - 7.3 Start preparation

Operation and use 2G40, 2G40 H
34
HATZ
Operator’s Manual
7.3 Start preparation
Procedure
Step Activity
1 Before the first start and when the fuel system is empty:
▪ Pump the fuel with the manual lever (see chapter 7.3.1 Pump-
ing fuel with the manual lever, page 34
2 Set the speed adjustment (see chapter 7.3.2 Setting the speed
control, page 35).
7.3.1 Pumping fuel with the manual lever
Requirements
Pre-pumping of fuel with the manual lever of the fuel feed pump is necessary
in the following situations:
▪ Engine shuts down due to empty fuel tank
▪ At first filling of the fuel tank
▪ After changing the fuel filter
Overview
1 Manual lever
2 Fuel feed pump
Procedure
Step Activity
1 Fill with fuel if necessary.
2 Actuate the manual lever(1) on the fuel feed pump until the fuel
audibly flows back into the fuel tank through the return line.