Technical data 2G40, 2G40 H
22
HATZ
Operator’s Manual
2 Engine type/specification (only for special equipment)
3 Engine serial number
4 Max. engine speed (rpm)
Always install the engine appropriate for the intended application to fulfill the
EPA and CARB exhaust requirements.
4.3 Physical operating conditions
Engine adjustment
The engine is normally adjusted to operate within the standard reference
conditions stipulated in ISO3046-1:
Parameter Unit Value
Intake air temperature °C +25
K 298
Relative humidity % 30
Air pressure
(at approx. 100 meters above sea
level)
kPa 100
NOTICE
If the machine is operated at high altitudes and high tempera-
tures, adjustment of the engine setting may be necessary if the
climatic conditions were not taken into account when the ma-
chine was ordered. If this is the case, please contact your near-
est HATZ service station.
4.4 Engine oil
Oil quality
All oil brands that meet at least one of the following specifications are suit-
able:
▪ ACEA – B3 / E4 or better
▪ API – CF / CH-4 or better
If engine oils of a low quality standard are used, the oil change interval must
be reduced to 150 operating hours.
To Next Page
Loading...
