Maintenance 2G40, 2G40 H
60
HATZ
Operator’s Manual
Procedure
Step Activity
1 Pull out the dipstick (1) and clean it.
2 Unscrew the oil filler plug (2).
3 Fill engine oil. For the specification and viscosity, see chapter
4.4 Engine oil, page 22. See chapter 4.1 Engine information and
filling quantities, page 20 for the engine oil capacity.
4 Reinsert the dipstick.
5 Pull out the dipstick and check the oil level.
6 If required, top up engine oil to the max. mark.
7 Reinsert the dipstick.
8 Screw in the oil filler plug.
Concluding the inspection work
Step Activity
1 Check the oil level after a short test run and correct if necessary.
2 Check the oil filter for tightness and retighten by hand if neces-
sary.
8.2.6 Cleaning the oil bath air filter
Safety notes
CAUTION
Danger of burns.
There is a danger of burns when working on a hot engine.
▪ Let the engine cool before maintenance.
CAUTION
Danger of environmental damage from spilled used oil.
Used oil is water-polluting.
▪ Do no allow it to enter the ground water, water bodies, or
sewage system.
▪ Collect the used oil and dispose of it according to local envi-
ronmental regulations.
To Next Page
Loading...
