Maintenance 2G40, 2G40 H
66
HATZ
Operator’s Manual
Overview
Preparation
Step Activity
1 Remove all air guide parts (see Overview).
Procedure
Step Activity
Dry contamination
1 Dry clean and blow out all air guide parts as well as the entire
cooling air area and the cylinder heads, cylinders and flywheel
blading with compressed air.
Moist or oily contamination
1 Disconnect the negative battery terminal.
2 Spray the entire area with a suitable cleaning solution according
to manufacturer instructions and then clean off with a jet of wa-
ter.
Do not spray components of the electrical equipment with a wa-
ter jet or high pressure jet during cleaning.
3 Blow dry the engine with compressed air.
4 Determine the cause of the oil contamination and have leaks
corrected by the HATZ service station.
5 Let the engine run warm to prevent rust formation.
To Next Page
Loading...
