Haulotte Group HA51JRT - User Manual

143 pages

Save Page as PDF

To Next Page

Operator's manual

NGINE

POWERED

ARTICULATED

LIFTS

, 12 - 26

24203 3237 0 E 06 10 EN

Operator's manual

Engine-powered articulated lifts, 12 - 26 m

HA120PX - HA16X - HA16SPX

(HA46SJRT) - HA16PX (HA46JRT) -

HA18SPX (HA51SJRT) - HA18PX

(HA51JRT) - HA20PX (HA61JRT) -

HA260PX (HA80JRT)

Main Page

Other manuals for Haulotte Group HA51JRT

Maintenance Book196 pages

Questions and Answers

L
Leslie MillerAug 7, 2025
What to do if the buzzer is constantly on in my Haulotte Group HA51JRT?
- N
  Nicholas MorrisAug 7, 2025
  The buzzer in your Haulotte Group Lifting Systems could be activated for several reasons: * The tilt or slope may be exceeding the authorized limit; lower the arm and boom. * The platform overload indicator may be triggered; remove some weight. * The hydraulic oil temperature may be too high; allow it to cool down. * The pump might not be working because the E-stop buttons are pulled out. * Faulty fuses could be the cause; replace them. * The batteries might be discharged or faulty; recharge or replace them. * There could be poor contact on the battery cables; clean and tighten the terminals.
R
Regina BranchNov 20, 2025
Why are the platform controls not responding on my Haulotte Group HA51JRT?
- M
  Megan HowardNov 20, 2025
  The platform controls on your Haulotte Group Lifting Systems may not be responding due to several reasons: * The ground control box selector key might be set to the ground control box position; turn it to the platform control box position. * The platform overload indicator might be active; remove some weight. * The 'Enable Switch' pedal may not be activated; keep pressure on the pedal during movement. * The button or joystick corresponding to the faulty movement might be defective; replace the knob or joystick. * The tilt or slope may be exceeding the authorized limit; lower the arm and boom. * If there's no high speed, the platform might be extended. * If there's no steering, there might not be enough hydraulic oil. * If the platform and turntable controls do not work, th...