HAUSSLER ALPHA - Speed Adjustment and Dough Removal

13
iThe locking clip must be pushed in to the stop otherwise the dough mixer will not
start.
iYou can set a maximum kneading me of 30 minutes. If you do not set a kneading
me then a kneading me which is saved on the device will run automacally.
 Switch the device on using the "Power" buon
E
.
 Set the kneading me using the arrow buons
F
and
G
.
The me display shows the kneading me set in two digits.
 Start the kneading cycle using the "Slow"
B
or "Fast"
C
buon as required.
The me display shows the me remaining.
Once the kneading me has ended, the dough mixer automacally switches o.
 The kneading cycle can be interrupted at any me using the "Stop" buon
D
. In
order to resume the cycle, press the "Slow"
B
or "Fast"
C
buon again.
Change speed
 The speed can be changed as required by rst pressing the "Stop" buon
D
fol-
lowed by the "Slow" buon
B
for the rst speed or "Fast"
C
for the second speed.
Removing the dough
iFor idencaon of the parts, see Tab. 3 on page 8.
 Li the protecve cover
2
up.
 Retain the lng head
1
at the locking clip
8
, pull the locking clip out to the stop
and guide the lng head upwards.
 Release the mixer bowl
3
by turning it to the le.
 Remove the mixer bowl
3
from the bowl mounng
5
.
Kneading