HAUSSLER ALPHA - Part Cleaning and Reassembly

17
Removing the dough hook and mixer bowl
 Li the protecve cover
2
up.
 Retain the lng head
1
at the locking clip
8
, pull the locking clip out to the stop
and guide the lng head upwards.
 Hold the mounng
1
for the dough hook rmly in one hand.
 Release the dough hook
4
by turning to the le and remove it from the dough
hook mounng
1
.
 Release the mixer bowl
3
by turning it energecally to the le and remove
the mixer bowl from the bowl mounng
5
.
Cleaning the parts
iThe mixer bowl and dough hook are dishwasher safe.
 First clean the mixer bowl
3
and the dough hook
4
roughly with a dough scraper.
 Then clean the mixer bowl
3
and the dough hook
4
with hot water and a normal
domesc dishwashing detergent or in a dishwasher.
 Clean the housing of the device with a damp cloth.
Installing the mixer bowl and dough hook
 Place the mixer bowl
3
on the bowl mounng
5
.
 Turn the mixer bowl
3
to the right unl it clicks into place.
 Check that the mixer bowl
3
is seated rmly in the bowl mounng
5
by turning
it slightly to the le and right.
 Place the dough hook
4
in the mounng
1
for the dough hook and turn it to
the right unl it reaches the stop.
 Check that the dough hook
4
is seated rmly in the drive unit by pulling on it.
 Slowly press the lng head
1
downwards.
iIf the lng head cannot be pressed downwards, turn the dough hook slightly.
 Push the locking clip
8
into the stop.
 Close the protecve cover
2
.
Cleaning