Hawking HWPS12UG User Manual

6.3 Setup the HWPS12UG’s IP Address
The print server must have a unique IP address in
order to be recognized by the network.
You can set up the IP address on various Unix
systems using any one of the following methods:
1. DHCP (Dynamic Host Configuration Protocol)
2. BOOTP (Bootstrap Protocol)
The print server will use the last three methods to
obtain its IP address automatically if its IP address is
configured as Auto (0.0.0.0).
6.3.1 DHCP
There are many Unix systems that support the DHCP
protocol and the procedures to configure the DHCP
server database are different. This manual does not
describe the DHCP server configuration on Unix
systems. It is highly recommended that the DHCP
server should be located on the same network as the
HWPS12UG.
6.3.2 BOOTP
If you have the BOOTP daemon, bootpd, running on
your UNIX and is accessible to the print server, you
can use the BOOTP protocol to set up the IP address
of the print server. We recommend that the BOOTP
server should be located on the same subnet as the
print server. If you use Network Information Services

Hawking HWPS12UG Specifications

General

Brand	Hawking
Model	HWPS12UG
Category	Print Server
Language	English