20
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
1) Remove two screws from the motor housing.
2) Slide the protection guard (14) over the motor housing.
3) Re-insert the two screws into the protection guard (14) and tighten the screws.
Mounting the auxiliary handle
1: align the auxiliary handle (6) with the mounting clamp (7) ensuring the holes are aligned.
2: fully push the bolt through the holes until the thread can be seen.
3: Screw the locking knob (5) onto the bolt ensuring the handle is securely fastened
6
5
7
To Next Page
