28
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
4) Insert the spring, put the spool with the spool carrier back by pushing the carrier down and turn it
clockwise until it locks.
Lock
Catch
Note: Take care not to lose the spring found inside the spool head.
5) Test if the line can release properly by pushing the spool button with your thumbs while pulling
the line with your fingers. The line should come out freely.
BEFORE OPERATION
WARNING: The charger and battery pack are specially designed to work together so
do not attempt to use any other devices. Never insert or allow metallic objects into
your charger or battery pack connections otherwise an electrical failure and hazard
will occur.
NOTE: The battery pack comes partly charged. Charge the battery pack prior to first use, ideally for
at least 60 minutes.
• Always pull the plug of the charger from the mains before removing or connecting the battery
pack to the charger.
• Never charge the battery pack when the ambient temperature is below 5°C or above 45°C.
• Never recharge a battery pack again immediately after rapid charging. This could overcharge the
battery pack, thus reducing the lifespan of the battery pack and charger.
• Rest the charger for at least 15 minutes between continuously charging sessions.
Checking battery capacity
Press the battery capacity level button to check the charging level of the battery pack. The status/
remaining capacity will be shown on the battery charging level indication light.
To Next Page
Loading...
