Hayward AquaRite series User Manual

How To: Change the Default Display
8
If the first reading represents a number followed by the letter ‘P’, then the default
reading has been changed to express the ‘Desired Output %’.
Step 2
To change the default reading back to the average salt, start by
pressing the ‘Diagnostics’ button two times.
Continue moving the switch up to ‘Super Chlorinate’ and back to
‘Auto’ until the display reads ‘AL-0’.
It takes about 30 seconds for the unit to settle back on the
default reading. It should now reflect the average salt level.
When the unit reads ‘AL-4’ move the switch up to ‘Super
Chlorinate’ and back to ‘Auto’.
77P
AL-4
AL-0
3200
Step 1
Step 3
Step 4

Hayward AquaRite series Specifications

General

Category	Salt Chlorination System
Salt Level	2700-3400 ppm
Voltage	120V/240V
Chlorine Output	1.45 lbs/day
Pool Size	40, 000 gallons
Flow Rate	20 GPM
Water Temperature Range	50°F - 100°F (10°C - 38°C)