¾Will not climb walls
Pool design or configuration
Pool design or configuration
• Broken impeller. Inspect and replace it if required. Inspect for tears that may allow
objects to pass through and entangle or damage the impeller.
• Defective pump motor can be identified by a slow or non-rotating impeller. Replace
the motor box assembly.
Machine problem
Machine problem
Page 39
Troubleshooting
• The pool bottom corner design may be too sharp. Some pool designs feature a
sharp, 90 degree bottom corner. A guideline for the best machine performance is a
corner radius similar in contour to a basketball. In a clean
pool the machine symptom
will be movement to the wall with repeated bumping and infrequent climbing, The
PVC rollers can be replaced with foam rollers only if a dirty pool condition is
ruled out.
• Clean
vinyl or tile pool surface is too slick. Replace the PVC rollers with foam rollers
only if a dirty pool condition is ruled out.
To Next Page
Loading...
