¾Runs only a few seconds or minutes
• Alternate handle position with each use.
• Be sure machine is not getting caught on obstructions in the pool such as raised
drains, in floor cleaning heads, toys, etc.
¾Cord twisting
Troubleshooting
Page 41
• Make sure the machine is submerged in the water. An out of water detection within a
few minutes will cause the machine to stop if not completely submerged.
• Check electrical source for proper voltage.
• If using an extension cord, test for proper voltage. An extension cord is not
recommended.
• Check for missing or broken impeller blades.
• Check for pump impeller obstruction.
• Check pump impeller for hard rotation and pump motor binding.
To Next Page
