What should I do if my Hayward Heat Pump displays high pressure protection due to a sensor issue?
If your Hayward Heat Pump shows a high pressure protection error and you suspect a sensor issue, verify the CN30/HP connectors on the card. If the sensor is open or short-circuited, consider replacing it.
What to do if my Hayward EasyTemp ECPI15MA shows a water outlet sensor fault?
To address a water outlet sensor fault on your Hayward Heat Pump, verify the N22/RES2 connectors on the board and the extension connector, and replace the sensor if necessary.
What to do if my Hayward EasyTemp ECPI15MA Heat Pump shows an outside temperature sensor fault?
To fix an outside temperature sensor fault on your Hayward Heat Pump, verify the CN12/PH connectors on the board and the extension connector, and replace the sensor if needed.
What to do if my Hayward Heat Pump shows a de-icing sensor fault?
To resolve a de-icing sensor fault on your Hayward Heat Pump, verify the CN8/OPT connectors on the board and the extension connector, and replace the sensor if necessary.
What to do if my Hayward Heat Pump shows a compressor aspiration sensor defect?
To address a compressor aspiration sensor defect on your Hayward Heat Pump, verify the CN7/OAT connectors on the board and the extension connector, and replace the sensor if needed.
What to do if my Hayward EasyTemp ECPI15MA shows a compressor discharge sensor fault?
To troubleshoot a compressor discharge sensor fault on your Hayward Heat Pump, verify the CN9/OHT connectors on the board and the extension connector, and replace the sensor if necessary.
General| Model | ECPI15MA |
|---|---|
| Category | Heat Pump |
| Refrigerant Type | R-410A |
| Phase | 1 |
| Max Water Temp | 104°F |
| Min Water Temp | 50°F |
| Min Ambient Temp | 50 °F |
| Heating Capacity | 15, 000 BTU/hr |
To Next Page