4.2.6 Malfunction display
There will be malfunction code showing on the controller screen when relative malfunction occurs.
If there are more than one malfuctions occurs at the same time, you can check the current error codes
list by pressing “ ” or “ ” key.
You can refer to the malfunction table to find out the failure cause and solution. For example：
Water Inlet Temp. Sensor failure
4.3. Parameter table
Meaning Default Remarks
Set-point of auto mode target temp.
27 Ajustable
Remark:
The wire controller can display the temperature unit as "℉" or "℃" according to the unit Model
you bought.
4. USAGE
12
To Next Page
Loading...
