USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions should always be fol-
lowed, including the following:
• READ AND FOLLOW ALL INSTRUCTIONS
• WARNING: Disconnect all AC power during installation.
• WARNING: Water in excess of 100 degrees Fahrenheit may be hazardous to
your health.
• WARNING: To reduce the risk of injury, do not permit children to use this product
unless they are closely supervised at all times.
• WARNING:DonotusetheOmniLogictocontrolrepitsorrelatedreequip-
ment.
• A green colored terminal marked “Grounding” is located inside the wiring compart-
ment. To reduce the risk of electric shock, this terminal must be connected to the
grounding means provided in the electric supply service panel with a continuous
copper wire equivalent in size to the circuit conductors supplying the equipment.
• One bonding lug for US models is provided on the external surface. To reduce
the risk of electric shock, connect the local common bonding grid in the area of
the swimming pool, spa, or hot tub to these terminals with an insulated or bare
copper conductor not smaller than 8 AWG US / 6 AWG Canada.
• Alleldinstalledmetalcomponentssuchasrails,ladders,drains,orothersimilar
hardware within 3 meters of the pool, spa or hot tub shall be bonded to the equip-
ment grounding bus with copper conductors not smaller than 8 AWG US / 6 AWG
Canada.
• SAVE THESE INSTRUCTIONS
To Next Page
Loading...
Need help?
General
