To Next PageTo Next Page
Need help?Do you have a question about the Hayward S0246S and is the answer not in the manual?
General| Brand | Hayward |
|---|---|
| Model | S0246S |
| Category | Water Filtration Systems |
| Language | English |
Explains how the sand filter system traps impurities from pool water using sand.
Covers locating, assembling the pump, filling the filter with sand, and connecting the valve.
Ensure connections are tight, filter has correct sand, and set valve to 'BACKWASH'.
Run pump for 2 minutes during backwash to remove impurities from the sand.
Run pump for about a minute during rinse until water in sight glass is clear.
Set valve to 'FILTER', restart, adjust valves, and note pressure for future backwashing.
Set valve to 'Filter' for normal filtration, typically for 6 to 8 hours daily.
Used for cleaning the filter when pressure rises 10 PSI above start-up pressure.
Evacuates dirty backwash water to a drain for about one minute after backwashing.
Discharges water directly to sewer, used for lowering pool level or removing very dirty water.
Bypasses the filter for rapid chemical dispersion or chlorination.
Cuts off circulation between filter and pump; must not be used with pump running.
Completely drain the tank by unscrewing the drain cap at the base. Leave cap off during winter.
Rotate and leave the valve handle in any position during winterization.
Drain the pump according to the specific pump manufacturer's instructions for winterizing.
Contact local dealer for service. Non-conforming repairs or non-genuine parts void responsibility.
One-year warranty for defects. Excludes frost, chemical damage, wear parts, and labor costs.
