Hayward S200 User Manual

IS200 Rev C
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 1
S200 Series
Owner’s Manual
High Rate Sand Filter
Basic safety precautions s
h
ou
ld
a
l
ways
b
e fo
ll
owe
d
, inc
l
u
d
ing t
h
e fo
ll
owing: Fai
l
ure to fo
ll
ow instructions
can cause severe injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for
one of the following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property
damage and if ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or property
damage and if ignored presents a potential hazard. It can also make consumers aware of actions that are
unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
Hayward Pool Products
620 Division Street, Elizabeth, NJ 07207
Phone: (908) 351.5400
www.hayward.com
Contents
Warnings………………………………2
Introduction……….…………..….…4
Installation……….……………..……4
Filter Base Installation……………6
Replacement Parts………….………7
Warrantee & Registration ………8
Model S200
IMPORTANT SAFETY INSTRUCTIONS
Use onl
y
Hi
g
h Rate Sand No. 20 Silica Sand (.45mm - .55mm)

Hayward S200 Specifications

General

Filter Type	Sand
Valve Type	Multiport
Flow Rate	50 GPM
Operating Pressure	50 PSI
Filter Tank Diameter	20 inches
Pipe Size	1.5 inches
Inlet/Outlet Size	1.5 inches

Summary

Safety Information

Important Safety Instructions

Basic safety precautions to prevent severe injury or death.

Hazard Warnings and Precautions

Details warnings for suction entrapment, hazardous pressure, separation, and electric shock.

Hyperthermia and Electrical Risks

Discusses risks of hyperthermia, electric shock, and proper grounding.

Installation and Setup

How the S200 Filter Works

Explains filter operation, backwashing, and rinsing processes.

General Installation Guidelines

Filter placement, valve assembly, sand loading, and plumbing.

Pump/Filter Platform Base Installation

Instructions for assembling the pump and filter onto the platform base.

Operation and Maintenance

Initial Filter Start-Up

Steps for priming and starting the filter system after installation.

Filter Control Valve Functions

Explains the purpose of each valve setting (Filter, Backwash, Rinse, etc.).

Winterizing Procedures

Procedures for draining and preparing the filter for winter.

Specifications, Parts, and Service

Service and Repairs Guidance

Advice on consulting dealers and basic water chemistry balance.

Filter Specifications and Parts

Technical specs, media requirements, and component diagram with part numbers.

Drain Pipe Assembly Installation

Instructions for installing the drain pipe assembly.

Product Warranty and Registration

Product Registration

Information for registering the product for warranty records.

Limited Warranty Details

Outlines the terms and conditions of the limited warranty for sand filters.