3.Operating the base*hazer*pro
3.1 Selection of the location
The location in which the base*hazer*pro will be used has to be
dry
• free from dusty or polluted air
•
• free from vibrations
•
• non-flammable place and surrounding
•
• well-ventilated with haze-free air
•
• keeping the ambient operating temperature between 10°C and 40°C and the relative humidity
below 80%.
3.2 Changing the fluid bottle, haze liquid and liquid consumption
Disconnect the fluid tube from lid by retracting the brass collar and removing the brass coupling
Remove the container from flightcase.
Unsrew the lid from the empty container and screw it onto the new container.
Place the full container into the flightcase. !Please note: Keep the lid of the full container a little open
when putting it back into the flightcase to allow the air to dissapear!
Push the brass coupling into the brass collar until you will hear a click. The brass collar is now locked
firmly.
The base*hazer*H – special liquid for use in the base*hazer*pro is available in 5-ltr. – and 25-ltr.-
bottles and 200-ltr.-barrels. You will find the Material Safety Data Sheet for base*hazer*liquid and
Document of Compliance under www.hazebase.com.
To guarantee the trouble-free operation of the base*hazer only the special base*H has to be used.
Use of other liquids will void the manufacturer`s warranty and can be dangerous to your health.
!PLEASE NOTE: The vaporizer of our machines does not have to be cleaned!
Cleaners, available on the market, can damage the vaporizer! We cannot grant
warranty in this case.
When operating on 99% pump output the base*hazer will cosume 0,6 ltr. / hour and on an output up to
5% the consumption will be 0,04 ltr. / hour.
To Next Page
Loading...