5.3 Operating via DMX 512
Connecting the base*hazer*pro to a DMX desk, use the DMX socket beside the control
panel. As soon as the machine receives a correct DMX signal, the yellow DMXLED
will be lit.
!Please note: The base*hazer*pro uses two channels on your desk! First Channel = Pump, second
Channel = Fan.
Adjusting the DMX start address
a) Press the Mode-button at the control panel until three figures appear on
the LED-display
b) Adjust the required start address by pressing the Up- or Down-button
c) Save the start address by pressing the Enter-button once. The start address
will now also be saved when you disconnect the machine from the mains supply.
Adjusting the pump and fan output in DMX use
If you run the machine via a DMX desk you can adjust the pump and the fan
directly from the desk from 1 to 99%.
The adjusted channel will control the pump, the following one will control the fan.
5.4 0 - 10 Volt (+) DC control
Connect the base*hazer to an analogue desk or to the optional cable remote by using the 3-pol-XLR-
socket beside the control panel.
!Please note: With the analogue control the pump can be adjusted from the desk and/ -or cable
remote. The fan has to be adjusted at the machine.
a) Put the cable from the desk or the cable remote into the 3-pol-XLR socket beside the control panel.
b) Put the pump up to 99% and adjust the required fan output at the machine
c) With the turnable button on the cable remote or with the fader on the analogue
desk the pump output can be regulated.
d) Pressing the On/Off switch at the cable remote starts the haze process. The
green Active-LED will be lit.
Adjusting the pump and fan output in analogue use
a) Press the Mode-button at the control panel until a P and two figures will appear
on the LED . Put the pump up to 99%.
b) Press the Mode-button at the control panel until an F and two figures will
appear on the LED display
c) Adjust the desired data (1 - 99%) by pressing the Up- or Down-button
d) The data for the pump can be regulated/adjusted via the turnable button on
the cable remote or the fader on your analogue desk.
5.5 Stand alone - use
The base*hazer*pro also can be used in the Stand alone mode. In this mode all data for the
pump and the fan must be adjusted directly at the machine
To Next Page
Loading...