4. Operating the base*hazer*pro
From the finest mist to a thick haze any desired effect can be achieved. These haze effects form
slowly so that the device should be switched on some time before the lighting or laser will start to
operate.
!Important: Do not connect a ducting to the nozzle of the base*hazer. If a ducting is connected
directly to the machine the haze will be pushed back into it. This may damage the machine. We can
not grant guarantee in this case!
5. Putting into operation
!Attention: Never connect the base*hazer*pro to a dimmer or switchpacke. This may destroy
the machine!
a. Connect the power plug to the mains supply. Make sure
the correct voltage is selected.
A P and two figures will appear on the LED-display.
b. After 60 Seconds, the base*hazer*pro is heated up. Press the Enter-button once to
start the haze process. The green Active-LED will be lit. After a short delay
the machine will start to haze.
After 30 Seconds the display will go dark. To re-activate it, press one of the
buttons on the display.
5.1 Switching the device off (general)
a. Press the Mode button till „OFF” will appear on the
display. After 15 Seconds the machine will switch into
the post-run-mode automatically. On the LED display
lines appear which move from upper left to the lower
right while the heater is cooling.
When the heater is cooled down, a red decimal point
will appear on the right bottom edge of the display.
b. When you switch off the DMX signal, the machine will be switched into the
post-run-mode to cool down automatically after 15 Seconds.
! Please note: Please make sure that the base*hazer*pro will not be disconnected too early to allow
the fan to run until the device has cooled down. This will ensure that no liquid remains in the vaporizer
to come out as droplets when the device is switched on the next time.
5.2 Control choices
You may control the base*hazer*pro externally through the XLR sockets.
!Please note: DMX takes priority. That means: when the machine is controlled
via DMX 512 this data takes priority over 0-10V (+) DC and Stand alone operation.
!Please note: You can‘t hold down the Mode-button for scrolling through the
Menu. The Mode-button has to be pressed only momentarily. If the Mode-button
is pressed more than two Seconds, the machine will change into the Timer-Mode
The outstanding feature is the adjustable output of the base*hazer*pro. The pump and
the fan can be easily and separately adjusted and regulated in 99 steps via buttons.
Any desired effect can be achieved in steps of 1%: from the finest mist to a thick
haze, similar to fog. To achieve the thickest effect the pump must run at 99%, the
fan at 1%. The finest haze can be achieved with lower pump and higher fan
settings. The data can be readjusted whenever you want to.
To Next Page
Loading...