Roommate AP Operations Manual Rev 1.0
Pillow Speaker
Pillow Speaker 1 Type Select the communication type from the pillow speaker Options are Phillips,
Zenith, or RCA.
Pillow Speaker 1 Analog Selection for a 1 button pillow speaker.
Audio
Speaker Mode Select the audio output. Options are (All) Off, TV Only, and Pillow Speaker
Only.
Power On Volume-Last Select to use the last volume level before power off.
Power On Volume Select a volume level the television starts at when powered on.
TV Speaker Min Select a minimum level the television speakers output.
TV Speaker Max Select a maximum level the television speakers output.
Pillow Speaker 1 Min Select a minimum level the pillow speaker outputs.
Pillow Speaker 1 Max Select a maximum level the pillow speaker outputs.
More…
Power On Source Sets the source for television when it is turned on. Select Source
Options are: Home, TV, AV, HDMI 1, HDMI2, HDMI 3, PC, or App.
Turn On Channel Set a channel to start up to when TV is set for Power On Source.
Power On App Set an App to start up to when App is set for Power On Source.
Serial Control Type Select the code to use for serial control. Options are HCI, DVD, and Off.
Dark Detect Enable/Disable Video Detection Circuit option when available.
LED Control Chose when the front LED should be lit. Options are Off, On When TV Off,
On When TV On, and Always On.
LED Response Blink When selected, front light will blink when using IR remote.
IR Band Sets the Type of IR being used. Selections are:
Off IR is disabled
Band 1 HCI Remote set to Band 1. (default)
Band 2 HCI Remote set to Band 2.
Band 3 Magnavox.
Band 4 Apex.
Notes: To change HCI IR remote from Band 1 to Band 2 and back, press and hold the POWER button for 10
seconds.
Band 3 and Band 4 are for use with universal remotes.
The IR button on the IR remote will toggle the IR band regardless of which band is selected. IR Band
can also be changed by pressing and holding the HOME button then pressing the VOL- button. Release
both. Repeat to toggle through all selections.